Hallo
Kennt jemand das o.g. original SME Teil ?
Dieses ist jedem SME Dreher beigelegt.Bestellnummer 1148.
Ich hatte das Teil ,das eine Unterlegscheibe aus Metall darstellt erst mal zur Seite gelegt, weil ich nicht wusste wohin damit.
Jetzt habe ich auf der SME Website ein Video vom SME 15 gesehen.
Darin wird die Nutzung dieser Scheibe klar.Sie wird zwischen Teller und Platte gelegt.
Ist aber leicht erhöht.Ich habe inzwischen alle Videos im Netz durchgesehen.Keiner benutzt das Teil.Warum nicht ?
In der BDA Steht folgendes
- Place the record spindle washer on the spindle followed by the record and clamp. The latter should be screwed down clockwise enough to deflect the record flat into firm contact with the platter. With a fingertip tap the record in three places equally over its surface and with a little practice it will soon become evident whether or not the record is touching the platter. If not, some further tightening may be necessary but this is not always the answer however and sometimes releasing the clamp a little may do more to effect the desired improvement.
Ich werde das am Wochenende testen.
Hat jemand schon Erfahrungen damit gesammelt ?
Gruss
Werner